Accommodation

Original manual page 60

Galley Stove:

There is a gimbaled stove with oven in the galley area. It comes with an operation and maintenance booklet provided by the stove manufacturer. The standard LPG gas bottle is located in a vapor-tight container located in the stern locker. The container is fitted with a drain and vent fitting on the transom. Keep these clear at all times.

A few additional points of operation for the standard LPG stove are below:

It is recommended that every time the LPG tank valve is opened for use, the operator close the valve and watch that the gauge needle remains constant. The gauge should read approximately 110 PSI. If you can detect a falling in pressure over a 15-minute period of time, there is a leak.

LEAKS CAN BE DANGEROUS.

1. If a leak occurs, check all appliance burners to see if they are in the "OFF" position.
2. Make sure the oven control is in the "OFF" position.
3. Check all fittings with a soap and water solution. NEVER USE A FLAME TO CHECK FOR LEAKS.

If you cannot find the leak, contact the stove manufacturer promptly.

To light the oven: Light the right front burner to bleed air from the system for at least one (1) minute. Turn the temperature control knob from the "OFF" position to the "PILOT ON" position. After this has been done, light the pilot in the oven (constant pilot). After the oven is lit, turn the oven temperature control knob to the desired temperature.

Notes on the Solenoid: The solenoid must be turned on to test gauge for leaks. Both the solenoid and the tank valve must be turned on to receive fuel. The solenoid is an electrical device for turning on or off the fuel from inside the cabin at the electrical panel.

Points to remember: All stoves have been safety tested, however, it is wise to remember to never leave the boat when oven or burners are on. Turn off the tank when you leave the boat for more than one or two days. Always blow out the pilot light when you will be away from the boat for more than two days, and check for leaks when you open the tank.

Upholstery Fabric Cleaning Instructions

1. Regular vacuum cleaning or brushing in the direction of the pile with a soft brush.
2. Stains should, if possible, be removed at once with a damp cloth. Do not allow stains to harden and age.
3. Greasy stains can be removed with ordinary cleaning fluid.
4. For overall cleaning, use commercial types of upholstery shampoo using only the foam to protect the back padding from moisture. After a minute or so, remove foam, and when dry, vacuum or brush in the direction of the pile.
5. Do not use heat such as an iron or steam.
6. The use of some kind of fabric protector such as "Scotch Guard" is strongly recommended when the cushions are new, and after each cleaning.
7. Cabin Shades: When shades become soiled, wipe off with Fantastic or similar product.
8. Brisa - Ultra leather HP: Care Instructions: Spot clean with mild soap and water. Air dry or dry quickly with warm setting of a hair dryer. For stubborn stains, use mild solvent. On the 3M 1-8 rating scale, with 8 being the best, the following results were achieved using mild detergent in the 1:50 solution with water.